Dell PowerEdge R910 Hardware Owner's Manual - Page 44
NVRAM_CLR jumper, Retry the BIOS update. If - number of cores per processor
View all Dell PowerEdge R910 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
Message Causes Corrective Actions BIOS Update Remote BIOS update Attempt Failed! attempt failed. Retry the BIOS update. If problem persists, see "Getting Help" on page 203. Caution! NVRAM_CLR jumper is installed on system board. NVRAM_CLR jumper is installed in the clear setting. CMOS has been cleared. Move the NVRAM_CLR jumper to the default position (pins 3 and 5). See Figure 6-1 for jumper location. Restart the system and re-enter the BIOS settings. See "Using the System Setup Program and UEFI Boot Manager" on page 63. CPU set to minimum frequency. The processor speed may be If not an intentional setting, intentionally set lower for check any other system power conservation. messages for possible causes. CPUs with different cache sizes detected. CPUs with different core sizes detected! System halted Mismatched processors have Ensure that all processors been installed in the system. have the same cache size, number of cores and logical processors, and power rating. Ensure that the processors are properly installed. See "Processors" on page 148. CPUs with different logical processors detected! System halted. CPUs with different power rating detected! System halted. 44 About Your System