Dell PowerEdge R910 Hardware Owner's Manual - Page 57
Warning: A fatal, Unsupported CPU - firmware
View all Dell PowerEdge R910 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
Message Causes Corrective Actions Unable to launch System Services image. System halted! System halted after F10 Restart the system and keystroke because System update the Lifecycle Services image is either Controller repository to the corrupted in the system latest software to restore full firmware or has been lost due functionality. See the to system board replacement. Lifecycle Controller user documentation for more information. The iDRAC6 Enterprise card Restore the flash memory flash memory may be using the latest version on corrupted. support.dell.com. See the iDRAC6 user's guide for instructions on performing a field replacement of the flash memory. Unexpected interrupt in protected mode. Improperly seated memory modules or faulty keyboard/mouse controller chip. Reseat the memory modules. See "Troubleshooting System Memory" on page 181. If the problem persists, see "Getting Help" on page 203. Unsupported CPU combination. Unsupported CPU stepping detected. Processor(s) is not supported Install a supported processor by the system. or processor combination. See "Processors" on page 148. Warning: A fatal A fatal system error occurred Check the SEL for error has caused and caused the system to information that was logged system reset! reboot. during the error. See the Please check the applicable troubleshooting system event log! section in "Troubleshooting Your System" on page 173 for any faulty components specified in the SEL. About Your System 57