Dell PowerEdge R910 Hardware Owner's Manual - Page 126
Installing an Expansion Card, Holding the card by its edges, position the card so that the card-edge
View all Dell PowerEdge R910 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 126 highlights
Installing an Expansion Card CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product. 1 Unpack the expansion card and prepare it for installation. For instructions, see the documentation accompanying the card. 2 Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet. 3 Open the system. See "Opening the System" on page 89. 4 Open the expansion-card latch and remove the filler bracket. See Figure 3-20. 5 Holding the card by its edges, position the card so that the card-edge connector aligns with the expansion-card connector. 6 Insert the card-edge connector firmly into the expansion-card connector until the card is fully seated. 7 Close the expansion-card latch. See Figure 3-20. 8 If applicable, install the screw to secure the expansion card to the system. 126 Installing System Components