Dell S3100 EMC Command Line Reference Guide for the Series 9.14.2.2 - Page 1772

Last failover Reason: Last failover type: None None -- Last Data Block Sync Record: -- stack-unit Config: succeeded Feb 25 2016 00:11:35 SSMGR: succeeded Feb 25 2016 00:11:35 Start-up Config: succeeded Feb 25 2016 00:11:35 Runtime Event Log: succeeded Feb 25 2016 00:11:35 Running Config: succeeded Feb 25 2016 00:11:38 ACL Mgr: succeeded Feb 25 2016 00:11:35 LACP: no block sync done STP: no block sync done SPAN: no block sync done CRYPTOMGR: succeeded Feb 25 2016 00:11:35 DellEMC# show system stack-ports Display information about the stacking ports on all switches in the stack. Syntax show system stack-ports [status | topology] Parameters status (OPTIONAL) Enter the keyword status to display the command output without the Connection field. topology (OPTIONAL) Enter the keyword topology to limit the table to just the Interface and Connection fields. Defaults Command Modes none • EXEC • EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide. Version 9.10(0.0) 9.10(0.0) 9.8(2.0) 9.8(0.0P5) 9.8(0.0P2) 9.7(0.0) 8.3.19.0 8.3.7.0 8.3.11.1 Description Introduced on the S3148. Increased the stacking range to 12 units in S3100 series. Introduced on the S3100 series. Introduced on the S4048-ON. Introduced on the S3048-ON. Introduced on the S6000. Introduced on the S4820T. Introduced on the S4810. Introduced on the Z9000. Usage Information The following describes the show system stack-ports command shown in the following example. 1772 Stacking