Dell S3100 EMC Command Line Reference Guide for the Series 9.14.2.2 - Page 436

Version 7.8.1.0 7.7.1.0 7.4.1.0 Description Introduced on the S-Series. Introduced on the C-Series. Introduced Usage Information Related Commands When you enable failover, BGP keeps track of IP or IPv6 ability to reach the peer remote address and the peer local address. Whenever either address becomes unreachable (for example, no active route exists in the routing table for the peer IP or IPv6 destination/local address), BGP brings down the session with the peer. • show ip bgp neighbors - display information on the BGP neighbors. neighbor local-as To accept external routes from neighbors with a local AS number in the AS number path, configure Internal BGP (IBGP) routers. Syntax neighbor {ip-address | peer-group-name} local-as as-number [no-prepend] To return to the default value, use the no neighbor {ip-address | peer-group-name} local-as command. Parameters ip-address peer-group-name as-number no prepend Enter the IP address of the neighbor in dotted decimal format. Enter the name of the peer group to set the advertisement interval for all routers in the peer group. Enter the AS number to reset all neighbors belonging to that AS. The range is from 0 to 65535 (2 byte), from 1 to 4294967295 (4 byte) or from 0.1 to 65535.65535 (dotted format). Specifies that local AS values do not prepend to announcements from the neighbor. Defaults Command Modes Command History Not configured. ROUTER BGP This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide. Version 9.10(0.1) 9.10(0.0) 9.10(0.0) 9.8(2.0) 9.8(1.0) 9.8(0.0P5) 9.8(0.0P2) 9.7(0.0) 9.2(1.0) Description Introduced on the S6010-ON and S4048T-ON. Introduced on the S3148. Introduced on the S6100-ON. Introduced on the S3100 series. Introduced on the Z9100-ON. Introduced on the S4048-ON. Introduced on the S3048-ON. Introduced on the S6000-ON. Introduced on the Z9500. 436 Border Gateway Protocol