Dell S3100 EMC Command Line Reference Guide for the Series 9.14.2.2 - Page 698

Example DellEMC# clear dampening gigabitethernet 1/10 Clear dampening counters on TeGi 1/10 [confirm] y DellEMC# Related Commands • show interfaces dampening - display interface dampening information. • dampening - configure dampening on an interface. combo-port-type You can pre-provision the medium of combo ports as copper or fiber. Syntax Parameters combo-port-type{copper | fiber} copper fiber Enter the keyword copper to provision the combo port as a copper port. Enter the keyword fiber to provision the combo port as a fiber port. Defaults Command Modes Command History None INTERFACE Version 9.11(0.0) 9.10(0.0) Description Introduced on the N20xx and N30xx series port extenders. Introduced on the S3100 series. Usage Information By default, a combo port is in Hybrid mode. Use the combo-port-type command to provision the combo port as either copper or fiber. Use the no combo-port-type command to change the combo port to Hybrid mode. The negotiation auto command is not available on the combo ports in the hybrid mode. You need to provision the combo port as copper or fiber medium using the combo-port-type command. Example Dell(conf-if-gi-1/23)# combo-port-type copper Dell(conf-if-gi-1/23)# combo-port-type fiber dampening Configure dampening on an interface. Syntax Parameters dampening [[[[half-life] [reuse-threshold]] [suppress-threshold]] [maxsuppress-time]] half-life reuse-threshold Enter the number of seconds after which the penalty is decreased. The penalty decreases half after the half-life period expires. The range is from 1 to 30 seconds. The default is 5 seconds. Enter a number as the reuse threshold, the penalty value below which the interface state is changed to "up". The range is from 1 to 20000. The default is 750. 698 Interfaces