Dell S3100 EMC Command Line Reference Guide for the Series 9.14.2.2 - Page 218

seq Assign a sequence number to a deny or permit filter in an IP access list while creating the filter. Syntax seq sequence-number {deny | permit} {source [mask] | any | host ip-address}} [count [byte] | log] [dscp value] [ecn value] [fragments] [monitor] [no-drop] [order] To delete a filter, use the no seq sequence-number command. Parameters sequence-number deny permit source mask any host ip-address count bytes log dscp ecn order monitor Enter a number from 0 to 4294967290. Enter the keyword deny to configure a filter to drop packets meeting this condition. Enter the keyword permit to configure a filter to forward packets meeting this criteria. Enter an IP address in dotted decimal format of the network from which the packet was received. (OPTIONAL) Enter a network mask in /prefix format (/x) or A.B.C.D. The mask, when specified in A.B.C.D format, may be either contiguous or non-contiguous. Enter the keyword any to specify that all routes are subject to the filter. Enter the keyword host then the IP address to specify a host IP address or hostname. (OPTIONAL) Enter the keyword count to count packets the filter processes. (OPTIONAL) Enter the keyword bytes to count bytes the filter processes. (OPTIONAL) Enter the keyword log to enter ACL matches in the log. (OPTIONAL) Enter the keyword dcsp to match to the IP DCSCP values. The range is from 0 to 63. (OPTIONAL) Enter the keyword ecn to match to the ECN values. The range is from 0 to 3. (OPTIONAL) Enter the keyword order to specify the QoS order for the ACL entry. The range is from 0 to 254 (where 0 is the highest priority and 254 is the lowest; lower-order numbers have a higher priority). If you do not use the keyword order, the ACLs have the lowest order by default (255). (OPTIONAL) Enter the keyword monitor to describe the traffic that you want to monitor and the ACL in which you are creating the rule is applied to the monitored interface. NOTE: For more information, see "Flow-based Monitoring" in the Port Monitoring section of the Dell EMC Networking OS Configuration Guide. fragments no-drop Enter the keyword fragments to use ACLs to control packet fragments. Enter the keywords no-drop to match only the forwarded packets. Defaults Command Modes Not configured CONFIGURATION-STANDARD-ACCESS-LIST 218 Access Control Lists (ACL)