Dell S3100 EMC Command Line Reference Guide for the Series 9.14.2.2 - Page 510

set extcommunity rt To set Route Origin community attributes in Route Map, use this feature. Syntax set extcommunity rt {as4 ASN4:NN [non-trans] | ASN:NNNN [non-trans] | IPADDR:NN [non-trans]} [additive] To delete the Route Origin community, use the no set extcommunity command. Parameters as4 ASN4:NN ASN:NNNN IPADDR:NN additive non-trans Enter the keyword as4 then the 4-octet AS specific extended community number in the format ASN4:NN (4-byte AS number:2-byte community value). Enter the 2-octet AS specific extended community number in the format ASN:NNNN (2byte AS number:4-byte community value). Enter the IP address specific extended community in the format IPADDR:NN (4-byte IPv4 Unicast Address:2-byte community value). (OPTIONAL) Enter the keyword additive to add to the existing extended community. (OPTIONAL) Enter the keywords non-trans to indicate a non-transitive BGP extended community. Defaults Command Modes Command History none ROUTE MAP (config-route-map) This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide. Version 9.10(0.0) 9.8(2.0) 9.8(0.0P5) 9.8(0.0P2) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 7.8.1.0 7.7.1.0 7.6.1.0 Description Introduced on the S3148. Introduced on the S3100 series. Introduced on the S4048-ON. Introduced on the S3048-ON. Introduced on the Z9500. Introduced on the S4820T Introduced on the Z-9000. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Usage Information If the set community rt and soo are in the same route-map entry, the behavior defines as: 510 Border Gateway Protocol