Dell S3100 EMC Command Line Reference Guide for the Series 9.14.2.2 - Page 821

Example (Error Messages) DellEMC# debug ip packet access-group test %Error: port operator GT not supported in access-list debug %Error: port operator LT not supported in access-list debug %Error: port operator RANGE not supported in access-list debug %Error: port operator NEQ not supported in access-list debug DellEMC#00:10:45: %RPM0-P:CP %IPMGR-3-DEBUG_IP_PACKET_ACL_AMBIGUOUS_EXP: Ambiguous rules not supported in access-list debug, access-list debugging is turned off DellEMC# icmp6-redirect enable Enable ICMP and ICMP6 redirects. Syntax Command Modes Command History icmp6-redirect enable EXEC Privilege This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide. Version Legacy command Description Legacy command Usage Information Use this command to notify hosts on the same network that a better route is available for a specific destination. The icmp6-redirect enable command is applicable for both IP and IPv6 routes. ip address Assign a primary and secondary IP address to the interface. Syntax ip address ip-address mask [secondary] To delete an IP address from an interface, use the no ip address [ip-address] command. Parameters ip-address mask secondary Defaults Command Modes Not configured. INTERFACE Enter an IP address in dotted decimal format. Enter the mask of the IP address in slash prefix format (for example, /24). (OPTIONAL) Enter the keyword secondary to designate the IP address as the secondary address. IPv4 Routing 821