Dell S3100 EMC Command Line Reference Guide for the Series 9.14.2.2 - Page 454

Version 7.8.1.0 7.7.1.0 Description Introduced on the S-Series. Introduced on the C-Series. Usage Information Timer values configured with the neighbor timers command override the timer values configured with any other command. When two neighbors, configured with different keepalive and holdtime values, negotiate for new values, the resulting values are as follows: • the lower of the holdtime value is the new holdtime value, and • whichever is the lower value; one-third of the new holdtime value, or the configured keepalive value, is the new keepalive value. neighbor timers extended Set idle hold time for a BGP neighbor or a peer group. Syntax neighbor {ip-address | ipv6-address | peer-group-name} timers extended idle holdtime To return to the default values, use the no neighbor {ip-address | ipv6-address | peer-groupname} timers extended idle holdtime command. Parameters ip-address Enter the IP address of the peer router in dotted decimal format. ipv6-address Enter the IPv6 address of the peer router in X:X:X:X::X format. peer-group-name Enter the name of the peer group to set the timers for all routers within the peer group. timers extended idle Enter a number for the time interval, in seconds, for the peer to be idle state. The range is holdtime from 1 to 32767. The default is 15 seconds. Defaults The default idle holdtime is 15 seconds. Command Modes Command History ROUTER BGP This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide. Version 9.14(0.0) Description Introduced on the C9010, MXL, FN IOM, S3100 series, S3048-ON, S4048-ON, S4048TON, S5048F-ON, S6000, S6010-ON, S6100-ON, Z9100-ON, and S6000-ON. Usage Information The peer remains in idle state based on the configured idle holdtime. The less the idle holdtime, less the peer in idle state. For the new idle holdtime to take effect, you need to shutdown the respective peer manually using neighbor shutdown command and enable the peer again. 454 Border Gateway Protocol