Dell S3100 EMC Command Line Reference Guide for the Series 9.14.2.2 - Page 76

stack-unit-number all bootvar clear-all nvram Enter the stack member unit identifier to restore only the mentioned stack-unit. The range is from 1 to 12. Enter the keyword all to restore all units in the stack. Enter the keyword bootvar to reset boot line. Enter the keywords clear-all to reset the NvRAM, boot environment variables, and the system startup configuration. Enter the keyword nvram to reset the NvRAM only. Command Modes Command History EXEC Privilege This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide. Version 9.10(0.0) 9.10(0.0) 9.8(2.0) 9.8(0.0P5) 9.8(0.0P2) 9.5(0.1) 9.2(1.0) 9.0.2.0 9.0.0.0 8.3.19.0 8.3.12.0 8.3.16.0 Description Introduced on the S3148. Increased the stacking range to 12 units in S3100 series. Introduced on the S3100 series. Introduced on the S4048-ON. Introduced on the S3048-ON. Added bootvar as a new parameter. Introduced on the Z9500. Introduced on the S6000. Introduced on the Z9000. Introduced on the S4820T. Introduced on the S4810. Introduced on the MXL 10/40GbE Switch IO Module. Usage Information Restoring factory defaults deletes the existing startup configuration and all persistent settings (stacking, fan-out, and so forth). When restoring all units in a stack, all the units in the stack are placed into stand-alone mode. When restoring a single unit in a stack, that unit placed in stand-alone mode. No other units in the stack are affected. When restoring units in stand-alone mode, the units remain in stand-alone mode after the restoration. After the restore is complete, the units power cycle immediately. CAUTION: There is no undo for this command. Following are the factory-default environment variables: • baudrate • primary_boot • secondary_boot • default_boot • ipaddr 76 File Management