Dell S3100 EMC Command Line Reference Guide for the Series 9.14.2.2 - Page 336

If ACL logging is stopped because the configured threshold is exceeded, it is re-enabled after the logging interval period elapses. ACL logging is supported for standard and extended IPv4 ACLs, IPv6 ACLs, and MAC ACLs. You can configure ACL logging only on ACLs that are applied to ingress interfaces; you cannot enable logging for ACLs that are associated with egress interfaces. You can activate flow-based monitoring for a monitoring session by entering the flow-based enable command in the Monitor Session mode. When you enable this capability, traffic with particular flows that are traversing through the ingress and egress interfaces are examined and, appropriate ACLs can be applied in both the ingress and egress direction. Flow-based monitoring conserves bandwidth by monitoring only specified traffic instead all traffic on the interface. This feature is particularly useful when looking for malicious traffic. It is available for Layer 2 and Layer 3 ingress and egress traffic. You may specify traffic using standard or extended access-lists. This mechanism copies all incoming or outgoing packets on one port and forwards (mirrors) them to another port. The source port is the monitored port (MD) and the destination port is the monitoring port (MG). Related Commands • permit - configure a filter to forward packets. permit udp (for IPv6 ACLs) Configure a filter to pass UDP packets meeting the filter criteria. Syntax permit udp {source address mask | any | host ipv6-address} [operator port [port]] {destination address | any | host ipv6-address} [operator port [port]] [ttl operator] [count [byte]] [log [interval minutes] [threshold-in-msgs [count]] [monitor] To remove this filter, you have two choices: • Use the no seq sequence-number command if you know the filter's sequence number. • Use the no permit udp {source address mask | any | host ipv6-address} {destination address | any | host ipv6-address} command. Parameters ttl operator Enter the keyword ttl to permit a packet based on the time to live value. The range is from 1 to 255. Enter one of the following logical operand: • eq(equal to) - matches packets that contain a ttl value that is equal to the specified ttl value. • neq(not equal to) - matches packets that contain a ttl value that is not equal to the specified ttl value. • gt(greater than) - matches packets that contain a ttl value that is greater than the specified ttl value. • lt (less than) - matches packets that contain a ttl value that is less than the specified ttl value. • range(inclusive range of values) - matches packets that contain a ttl value that falls between the specified range of ttl values. log threshold-in msgs count (OPTIONAL) Enter the keyword log to enable the triggering of ACL log messages. (OPTIONAL) Enter the threshold-in-msgs keyword followed by a value to indicate the maximum number of ACL logs that can be generated, exceeding which the generation of ACL logs is terminated with the seq, permit, or deny commands. The threshold range is from 1 to 100. 336 Access Control Lists (ACL)