Dell S3100 EMC Command Line Reference Guide for the Series 9.14.2.2 - Page 663

Example Field RPM Failover Record Last Data Sync Record Description • the data sync method configured (the redundancy synchronize command) • the failover type (you cannot change this type; it is software-dependent). Hot Failover means that the running configuration and routing table are applied on secondary RPM. Fast Failover means that the running configuration is not applied on the secondary RPM until failover occurs, and the routing table on line cards is cleared during failover. • the status of auto booting the RPM (the redundancy disable-auto-reboot command) • the parameter for auto failover limit control (the redundancy auto-failoverlimit command) • Displays the following information: • RPM failover counter (to reset the counter, use the redundancy resetcounter command) • the time and date of the last RPM failover • the reason for the last RPM failover Displays the data sync information and the timestamp for the data sync: • Start-up Config is the contents of the startup-config file. • Line Card Config is the line card types configured and interfaces on those line cards. • Runtime Event Log is the contents of the Event log. • Running Config is the current running-config. This field only appears when you enter the command from the Primary RPM. DellEMC# show redundancy -- RPM Status -- RPM Slot ID: 1 RPM Redundancy Role: Primary RPM State: Active RPM SW Version: 7.5.1.0 Link to Peer: Up -- PEER RPM Status -- RPM State: Standby RPM SW Version: 7.5.1.0 -- RPM Redundancy Configuration -- Primary RPM: rpm0 Auto Data Sync: Full Failover Type: Hot Failover Auto reboot RPM: Enabled Auto failover limit: 3 times in 60 minutes -- RPM Failover Record -- Failover Count: 1 Last failover timestamp: Jul 13 2007 21:25:32 Last failover Reason: User request -- Last Data Block Sync Record: -- High Availability (HA) 663