Dell Vostro 2510 Service Manual - Page 31

Memory : Dell Vostro 2510 <br>Service Manual, Removing a Memory Module - specifications

Get Dell Vostro 2510 PDF manuals and user guides View all Dell Vostro 2510 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 31 highlights

Back to Contents Page Memory Dell™ Vostro™ 2510 Service Manual Removing a Memory Module Replacing a Memory Module Your computer has two user-accessible SODIMM sockets, both accessed from the bottom of the computer. You can increase your computer memory by installing memory modules on the system board. See "Specifications" in your Setup and Quick Reference Guide for information on the memory supported by your computer. Install only memory modules that are intended for your computer. NOTE: Memory modules purchased from Dell are covered under your computer warranty. Removing a Memory Module CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance. 1. Follow the procedures in Before Working on Your Computer. 2. Turn the computer upside down. 3. Remove the two screws that secure the memory cover, then remove the cover and set it aside. (See Removing a Memory Module for an illustration of the memory cover.) 1 memory cover 2 screws (2) NOTICE: To prevent damage to the memory module connector, do not use tools to spread the memory module securing clips. 4. Use your fingertips to carefully spread apart the securing clips on each end of the memory module connector until the memory module pops up.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
Back to Contents Page
Memory
Dell™ Vostro™ 2510
Service Manual
Removing a Memory Module
Replacing a Memory Module
Your computer has two user-accessible SODIMM sockets, both accessed from the bottom of the computer.
You can increase your computer memory by installing memory modules on the system board. See "Specifications" in your
Setup and Quick Reference Guide
for information on the memory supported by your computer. Install only memory modules
that are intended for your computer.
NOTE:
Memory modules purchased from Dell are covered under your computer warranty.
Removing a Memory Module
CAUTION:
Before working inside your computer, read the safety information that shipped with your
computer. For additional safety best practices information, see the Regulatory Compliance Homepage at
www.dell.com/regulatory_compliance.
1. Follow the procedures in
Before Working on Your Computer
.
2. Turn the computer upside down.
3. Remove the two screws that secure the memory cover, then remove the cover and set it aside. (See
Removing a
Memory Module
for an illustration of the memory cover.)
1
memory cover
2
screws (2)
NOTICE:
To prevent damage to the memory module connector, do not use tools to spread the memory module
securing clips.
4. Use your fingertips to carefully spread apart the securing clips on each end of the memory module connector until the
memory module pops up.