Dell W5300n Dell™ Workgroup Laser Printer W5300 User's Guide - Page 142
Option in Slot X, Firmware Card
View all Dell W5300n manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 142 highlights
4 Unsupported Firmware Card Setup Menu. Install additional printer memory. The printer detects an unsupported version of firmware on the installed firmware card during the power-on cycle. See also: Setup Menu Turn the printer off, and then press and hold Go while turning it on. The printer reads the code on the system card and bypasses the code on the firmware card. Remove the firmware card. 54 Network Software Error The printer cannot establish communications with an installed network port. 54 Std Network Software Error Press Go to clear the message and continue printing. The job may not print correctly. Program new firmware for the network interface by way of the parallel port. Press Menu to open the Job Menu and reset the printer. 55 Unsupported Flash in Slot X The printer detects an Turn the printer off. Remove the unsupported flash memory card in unsupported option card. one of the connectors. 55 Unsupported Option in Slot X The printer detects an Turn the printer off. Remove the unsupported option card in one of unsupported option card. the connectors. 56 USB Port Disabled Data has been sent to the printer through a USB port, but the USB port is disabled. Press Go to clear the message. The printer discards any data received through the USB port. Make sure the USB Buffer menu item in the USB Menu is not set to Disabled. 56 Standard USB Port Disabled See also: USB Buffer 58 Too Many Trays Attached Too many drawers with matching Turn off and unplug the printer. Remove trays are installed on the printer. the additional drawers. Plug in the printer and turn it on. You have installed an Remove the device and press Go to clear