Epson Endeavor User Setup Information - Page 32
Setting the Self Test Error Level, stop if it finds an error during the self test.
View all Epson Endeavor manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
If you install one type of display adapter card and then change the adapter (from VGA to CGA or vice-versa), you also may need to set jumper J5. If you have two types of cards, set the jumper to match the adapter controlling your primary display. See Chapter 2 in the User's Guide for instructions on changing jumper settings and the manual that came with your monitor for additional information. Setting the Self Test Error Level When you start your system, it performs a self test. The Halt On option determines the point at which the system will stop if it finds an error during the self test. If your computer is running without a keyboard or diskette drive or it must always start, you can choose one of the options in the following table to ensure the computer will boot. Self test error levels Select If All Errors* You want your system to stop booting if it encounters any errors during the self test No Errors You don't want your system to stop booting, even if it encounters errors during the self test All But Keyboard You want your system to stop booting if it encounters any error except a keyboard error during self test All But Diskette You want your system to stop booting if it encounters any error except a diskette drive error during self test All But Diskette/ Keyboard You want your system to stop booting if it encounters any error except either a diskette drive error or a keyboard error during self test l Default setting 2-6 Running the SETUP Program