Epson Endeavor User Setup Information - Page 45
Setting the I/ O Control Options, You may need to change these settings if you install an
View all Epson Endeavor manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
Setting the I/O Control Options The I/O control options let you change the settings for the following built-in interface ports: 0 Parallel Cl Serial 1 Cl Serial 2 Q Hard disk drive controller (IDE) Cl Diskette drive controller (FDC). You may need to change these settings if you install an interface on an option card. The following table lists the possible settings. I/O control options I/O control option Setting COM1 Select Enabled* Disabled COM2 Select Enabled* Disabled Parallel Port Address 03BCH 0378H* 0278H Disabled Description Enables the COM1 serial port Disables the COM1 serial port Enables the COM2 serial port Disables the COM2 serial port Sets the parallel port address to 03BCH Sets the parallel port address to 0378H Sets the parallel port address to 0278H Disables the parallel port Running the SETUP Program 2-19