Epson Endeavor User Setup Information - Page 48
Saving Your Settings and Exiting SETUP, PRESS F5 TO SAVE AND EXIT, PRESS F1 TO EXIT W/O SAVE
View all Epson Endeavor manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
Saving Your Settings and Exiting SETUP When you leave the SETUP program, you can choose to either save the settings you have changed or exit the program without saving any changes. Follow these steps: 1. Press (w]. You see the following prompt: PRESS F5 TO SAVE AND EXIT PRESS F1 TO EXIT W/O SAVE 2. If you want to save your changes, ress (7). If you don't want to save your changes, press . Either way, the system reboots. 3. If you have just run SETUP for the first time, see "Post-SETUP Procedures," below. Note You may see an error message and a prompt to run SETUP when your computer is rebooting if it detects a problem in your SETUP configuration. If so, follow the instructions on the screen to run SETUP and correct the problem. You may also see an error message when your computer is rebooting if you have not installed your operating system on the hard disk and you have not inserted a system diskette in drive A. If you receive this error message, follow the instructions in your operating system manuals to install the software on your computer. 2-22 Running the SETUP Program