Epson Stylus COLOR 850N User Manual - Epson Stylus RIP Mac & PC - Page 14

Checking the Printer

Get Epson Stylus COLOR 850N - Ink Jet Printer PDF manuals and user guides View all Epson Stylus COLOR 850N manuals
Add to My Manuals
Save this manual to your list of manuals

Page 14 highlights

Installing EPSON Stylus RIP for Macintosh Checking the Printer Before you install the EPSON Stylus RIP software, follow the instructions in your printer's documentation to prepare your printer for use. Make sure you perform the following steps:  If you'll be using the printer in a "typical" network configuration (described in the following section), install an optional network interface card in the printer. See your printer's documentation for instructions. (Not every printer has a network interface card option.)  Load paper, install ink cartridges, and allow your printer to complete its entire ink charging cycle.  Run a printer self test to make sure it operates properly.  Connect the printer directly to your Macintosh or to the network.  Install the standard non-PostScript EPSON driver and utilities that came with your printer.  Send a sample print job with the standard printer driver to make sure the interface connection and cable are secure and the software is installed correctly. Once the printer is set up and tested fully, you're ready to install the EPSON Stylus RIP software on your system. 1-2

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
1-2
Installing EPSON Stylus RIP for Macintosh
Checking the Printer
Before you install the EPSON Stylus RIP software, follow the
instructions in your printer’s documentation to prepare your
printer for use. Make sure you perform the following steps:
If you’ll be using the printer in a “typical” network
configuration (described in the following section), install an
optional network interface card in the printer. See your
printer’s documentation for instructions. (Not every
printer has a network interface card option.)
Load paper, install ink cartridges, and allow your printer to
complete its entire ink charging cycle.
Run a printer self test to make sure it operates properly.
Connect the printer directly to your Macintosh or to the
network.
Install the standard non-PostScript EPSON driver and
utilities that came with your printer.
Send a sample print job with the standard printer driver to
make sure the interface connection and cable are secure and
the software is installed correctly.
Once the printer is set up and
tested fully
, you’re ready to
install the EPSON Stylus RIP software on your system.