HP 4550 Service Manual - Page 148
Right side cover, To remove the right side cover from the printer, Reinstallation tip
View all HP 4550 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 148 highlights
CAUTION CAUTION Right side cover To remove the right side cover from the printer 1 Open the drum drawer (top drawer) and remove the imaging drum, protecting it from light. 2 Remove the top cover. Exposure to light for more than 15 seconds can seriously damage the imaging drum. 3 Open the ITB drawer (middle drawer) and Tray 2. 4 Remove the two screws shown in callout 1, Figure 6-4. 5 Carefully pull out the bottom of the cover, and disengage the two tabs located behind the cover (see callout 2, Figure 6-4) by sliding the cover to the rear. Lift the cover up and off. Reinstallation tip When reinstalling the cover, ensure that the tabs on the inside of the cover (callout 2, Figure 6-4) are seated properly by pushing in firmly on the tabs while sliding the cover forward into position. 2 1 Figure 6-4 Right side cover removal and replacement 146 Removal and replacement C7085-90921