HP 4550 Service Manual - Page 61
Connecting a parallel cable, Your system will sense the printer if your system is Plug and Play
View all HP 4550 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
1 Connecting a parallel cable 1 Press the printer standby button (power switch) to place the printer in standby mode. Turn off the computer. 2 Plug the parallel cable into the printer's parallel port until it snaps into place. 3 Plug the other end of the parallel cable into the computer. Tighten the screws on the parallel cable to secure the cable to the computer. 2 4 Turn the computer on and then turn the printer on. Note Your system will sense the printer (if your system is Plug and Play compatible). Follow the directions on your screen. To install the complete software package, cancel Plug and Play, and see the getting started guide for more information. 3 4 C7085-90921 Chapter 3 Installation and configuration 59
C7085-90921
Chapter 3 Installation and configuration
59
Connecting a parallel cable
1
Press the printer standby button (power switch) to place the printer
in standby mode. Turn off the computer.
2
Plug the parallel cable into the printer’s parallel port until it snaps
into place.
3
Plug the other end of the parallel cable into the computer. Tighten
the screws on the parallel cable to secure the cable to the computer.
4
Turn the computer on and then turn the printer on.
Note
Your system will sense the printer (if your system is Plug and Play
compatible). Follow the directions on your screen. To install the
complete software package, cancel Plug and Play, and see the getting
started guide for more information.
3
4
2
1