HP 4550 Service Manual - Page 59
Installing the imaging drum, READY
View all HP 4550 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 59 highlights
91 Installing the imaging drum CAUTION Avoid exposing the imaging drum to direct light. Exposure to light for more than 15 seconds can seriously damage the imaging drum. 1 Pull open the drum drawer until it stops. 2 Align the imaging drum over the drawer so that the arrow on top 120 points to the rear of the printer, and the blue end cap on the side slides into the slot identified with the blue arrow. 3 Slide the imaging drum down into place. 4 Push the front upper drawer shut. Wait while the printer runs an internal color calibration. The calibration takes a few minutes. When the printer is ready, the control panel displays READY. CAUTION 3 If you need to ship the printer, remove the toner cartridges and imaging drum before shipping. 4 C7085-90921 Chapter 3 Installation and configuration 57