HP Color LaserJet Managed MFP E77822-E77830 On-Site Installation Guide - Page 93
On-site final setup booklet maker finisher with punch continued, Table 8-9
View all HP Color LaserJet Managed MFP E77822-E77830 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 93 highlights
Table 8-9 On-site final setup booklet maker finisher with punch (continued) ❑ Open the front door on the finisher and remove all foam and tape inside the finisher. ❑ Pull out the booklet maker and install two staple cartridge holders in the top of the booklet maker. ❑ Slide the booklet maker into the finisher. ❑ Remove the stapler lock screw and label. ❑ Rotate the green wheel to the left until the spring loaded white tab is exposed under the stapler. ❑ Rotate the green wheel to the right until the stapler moves back to the front position and stops. ❑ While holding the green wheel, insert the staple cartridge holder into the stapler. ❑ Follow these steps to install the optional hole punch. ❑ Remove two screws and remove the punch unit access panel on the rear of the finisher. ❑ Remove two screws and remove the "dummy" punch unit. NOTE: Save the dummy punch in the event the hole punch fails; it's needed if the hole punch is removed. ❑ Locate the alignment pin and tab at the front of the punch unit and the mounting bracket at the rear. NOTE: Be careful when handling the punch unit. Do not damage the mylar guides or the encoder wheel. ❑ Carefully slide the punch unit into the finisher. Align the mounting bracket at the rear. NOTE: The punch unit is properly seated when the mounting bracket at the rear is flush against the finisher frame. ❑ Note the orientation of the pins on the connector. While supporting the connector on the finisher side, insert the hole punch cable connector. ❑ Install one screw to secure the punch unit in the finisher. ❑ Replace the punch unit access panel and secure with two screws. ❑ Open the front door of the finisher and install the punch waste bin label. ❑ Pry the cover out of the punch waste bin opening and install the punch waste bin. ❑ Hang the lower tray support brackets on the horizontal bracket on the output side of the finisher. ❑ Secure each one with a screw. ❑ Note the alignment pins on the bottom of the tray and the corresponding holes on the support brackets. ❑ Position the tray over the brackets and push down firmly to seat the pins in the holes. ❑ While holding the tray from above, install four screws to secure the tray to the support brackets. ❑ Note the four tabs, install the upper tray into the slots. ❑ Install the front (F) and the rear (R) finisher attachment brackets on the left side of the engine. ❑ Secure with two screws in each bracket. ❑ Peel the cover off the connector near the rear bracket. ❑ Position the finisher near the left side of the engine and connect the two cables. ❑ Open the finisher front door and pull out the locking rail until it stops. ENWW Finishers 87