HP DesignJet T7200 Using Your Printer - Page 37
Unload a roll from the printer
View all HP DesignJet T7200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
18. If the paper that you are using has a barcode printed on the leading edge of the roll, and Printing paper info is enabled, the printer automatically reads the information. If Printing paper info is enabled and no barcode is detected on the roll that is being loaded, the front panel asks you to enter the paper type and the length of the roll you are loading. Select the paper category and paper type of the roll. If it is not clear which paper category or paper type to select, see Supported paper types on page 23. Select the length of the roll. 19. The printer performs some paper calibrations, after which the roll is ready for use. NOTE: During initial printer setup, printhead alignment and color calibration are performed automatically after the roll is loaded into the printer. If you experience a problem while loading the paper, follow the instructions on the front panel to load successfully. If you cancel the load, the paper will be unloaded. Here are some problems that can occur: ● Paper not found. Check that the paper type is supported (perhaps it's transparent). ● Right edge of roll too far from blue line. Check that the paper is correctly aligned with the right hub. ● Back door unexpectedly opened. Do not open the back door during a roll load. ● End of roll reached. In this case, the paper is ejected at the front of the printer. Unload a roll from the printer 1. At the printer's front panel, select the icon, and then select Unload paper. 2. All rolls are put on standby, and the paper is unloaded. If Printing paper info is enabled, the barcode is printed on the paper edge (see Printing paper info on page 33). 3. Wait until the front panel asks you to open the roll door, then open it. ENWW Unload a roll from the printer 29