HP DesignJet T7200 Using Your Printer - Page 80

Install the folding device NOTE: Only folding devices listed in the HP hardware solutions programs may be connected to the printer. 1. Set up the folding device and mechanically connect it to the printer as explained by the folding-device manufacturer. 2. Connect the cable between the folding device and the printer. 3. Switch on the folding device. 4. Select the icon on the printer's front panel, then Accessories > Folder > Install folder. 5. Select the default behavior when a print job comes without folding instructions: Accessories > Folder > Select default folding style. Uninstall the folding device 1. To uninstall the folding device, select the Uninstall folder. icon on the printer's front panel, then Accessories > Folder > 2. Remove the folding device from the printer. 3. Disconnect the cables between the printer and the folding device. Choose paper for the folding device For best performance, use the following: ● Plain or coated paper ● 75 to 90 g/m² ● 3-inch roll core See the documentation of the folding device for minimum and maximum supported paper sizes, and for more details of supported paper types. Select folding style The folder may support various folding styles, which are displayed on the Embedded Web Server's Submit Job options page. For more details, see the documentation of the folding device. ● On the Embedded Web Server's Submit Job page: Select Advanced Settings > Job Output > Folding Styles. The pull-down menu shows the folding styles supported by the installed folding device. ● On the folding device front panel: You can use the folding device's front panel to specify the folding style to apply to the print job when your application doesn't support folding styles. In this case, make sure the default folding style in the printer's front panel (Accessories > Folder > Select default folding style) is set to From folder front panel. 72 Chapter 8 Setup of folding devices ENWW