HP Dl180 ProLiant DL180 Generation 5 Server Maintenance and Service Guide - Page 44

Description, To remove the backplane

Get HP Dl180 - G6 E5504 2X2gb 4Lff Svr PDF manuals and user guides
UPC - 883585990917
View all HP Dl180 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 44 highlights

Figure 23 Backplane connectors of server with 12 HDD (solder side) Item 1 2 3 4 5 Description 10-pin power connector SAS controller IC LED signal cable connect to BPD SAS connector Cable connectors WARNING: Ensure that the system is powered off and all power sources have been disconnected from the server. Voltages are present at various locations within the server whenever an AC power source is connected. This voltage is present even when the main power switch is in the off position. To remove the backplane: 1. Remove all drives out of the drive bays. Refer to the "Hard drives" sections in this chapter for detailed procedures. Removal and replacement procedures 44

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
Removal and replacement procedures
44
Figure 23
Backplane connectors of server with 12 HDD (solder side)
Item
Description
1
10-pin power connector
2
SAS controller IC
3
LED signal cable connect to BPD
4
SAS connector
5
Cable connectors
WARNING:
Ensure that the system is powered off and all power sources have been disconnected
from the server. Voltages are present at various locations within the server whenever an AC power
source is connected. This voltage is present even when the main power switch is in the off position.
To remove the backplane:
1.
Remove all drives out of the drive bays.
Refer to the “Hard drives” sections in this chapter for detailed procedures.