HP EVA P6550 HP P6300/P6500 EVA User Guide (5697-2486, September 2013) - Page 188

Table 27 Error Messages (continued) Status code value Meaning How to correct 95 Unknown remote DR group The remote Continuous Access group specified does not exist. Correctly select the remote Continuous Access group retry the request. 96 PLDMC failed This error is no longer supported. Report the error to product support. 97 Storage system could not be locked. System busy. Try command again. Another process has already taken the SCMI Retry the request later. lock on the storage system. 98 While the request was being performed, an Resolve the condition and retry the Error on remote storage system. error occurred on the remote storage system. request 99 The DR operation can only be completed when the source-destination connection is down. If you are doing a destination DR deletion, make sure the connection link to the source DR system is down or do a failover operation to make this system the source. The request failed because the operation cannot be performed on a Continuous Access connection that is up. Resolve the condition and retry the request. 100 Login required - password changed. The management software is unable to log into the device as the password has changed. The storage system password may have been re-configured or removed. The management software must be used to set the password up to match the device so communication can proceed. 101 Maximum logins The maximum number of login sessions allowed to the storage system has been reached. Log out of a management agent session before attempting a new login. 102 Invalid Cookie The command cookie sent in the attempted Retry the operation later. If the error command is invalid. persists, report the error to product support. 103 Login Timed Out The login session is no longer valid due to Log in again. timeout. 104 Maximum Snapshot Depth The virtual disk has reached the maximum Remove a snapshot before attempting number of allowed snapshots. this command again. 105 Attribute Mismatch Case 1: Creation of the virtual disk failed due to an invalid capacity value. Case 2: Virtual disk mirror policy does not match other snapshots. Case 1: Specify a valid capacity value. Case 2: Choose a valid mirror policy value. 106 Password Not Set 107 Not Host Port 108 Duplicate LUN WWID 109 System Inoperative 110 Management agent was not able to log in Set a password before logging in. because password is not set. Without a password no login is required. Invalid port when trying to get host port information. Check if the port number refers to a valid host port and try again. A virtual disk with this WWID is already presented. Unpresent the already presented virtual disk or change the WWID of this virtual disk. This error is no longer supported. Report the error to product support. This is an internal error. Report the error to product support. 188 Error messages