HP EVA P6550 HP P6300/P6500 EVA User Guide (5697-2486, September 2013) - Page 28
Management module, iSCSI and iSCSI/FCoE recessed maintenance button, the HP P6000 Control Panel
![]() |
View all HP EVA P6550 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
Figure 11 Fan module pulled out 1. Green-Fan normal operation LED Table 6 Fan status indicators Status indicator On left-Green Fault indicator Solid green Blinking Off On right-Amber On 2. Amber-Fan fault LED Description Normal operation. Maintenance in progress. Amber is on or blinking, or the enclosure is powered down. Fan failure. Green will be off. (Green and amber are not on simultaneously except for a few seconds after power-up.) Management module The HP P6000 Control Panel provides a direct interface to the management module within each controller. From the HP P6000 Control Panel you can display storage system status and configuration information, shut down the storage system, and manage the password. For tasks to perform with the HP P6000 Control Panel, see the HP P6000 Control Panel online help. The HP P6000 Control Panel provides two levels of administrator access and an interface for software updates to the management module. For additional details about the HP P6000 Control Panel, see the HP P6000 Control Panel online help. NOTE: The HP P6350 and P6550 employ a performance-enhanced management module as well as new batteries. This requires HP P6000 Command View 10.1 or later on the management module and XCS 11000000 or later on the P6350 and P6550. iSCSI and iSCSI/FCoE recessed maintenance button The iSCSI and iSCSI/FCoE recessed maintenance button is the only manual user-accessible control for the module. It is used to reset or to recover a module. This maintenance button is a multifunction momentary switch and provides the following functions, each of which causes a reboot that completes in less than one minute: • Reset the iSCSI or iSCSI/FCoE module and boot the primary image • Reset the iSCSI or iSCSI/FCoE MGMT port IP address • Enable iSCSI or iSCSI/FCoE MGMT port DHCP address • Reset the iSCSI or iSCSI/FCoE module to factory defaults 28 P63x0/P65x0 EVA hardware
![](/manual_guide/products/hewlettpackard-eva-p6550-hp-p6300p6500-eva-user-guide-56972486-2013-4330a37/28.png)