HP EVA P6550 HP P6300/P6500 EVA User Guide (5697-2486, September 2013) - Page 189

Table 27 Error Messages (continued) Status code value Meaning How to correct Snapclone Active 111 EMU Load Busy The operation cannot be completed while the drive enclosures are undergoing code load. Wait several minutes for the drive enclosure code load to finish, then retry the operation. 112 Duplicate User Name An existing Continuous Access group already has this user name. Change the user name for the new Continuous Access group or delete the existing Continuous Access group with the same name. 113 The operation is not allowed because the Allow the drive to finish code load. Drive Reserved For Code Load drive is in a migrate code load state. 114 Already Presented This error is no longer supported. Report the error to product support. 115 Invalid Remote Storage Cell This error is no longer supported. Report the error to product support. 116 The SCMI lock context in StorageCell is Retry the operation later. If the error No Management Interface Lock empty where the lock is expected to be taken persists, report the error to product by the management agent. support. 117 Maximum Members The specified Continuous Access group already has the maximum number of members. Use another Continuous Access group or remove members from the existing Continuous Access group. 118 Maximum Destinations The specified Continuous Access group is Use an existing destination or stop attempting to use a new destination past the using a destination. maximum number. 119 Empty User Name The user name field for the specified Continuous Access group is empty. Populate the user name field. 120 Storage Cell Exists The command is not valid when a Use the command form designed to StorageCell is already formed and the NSC be used when no storage sell exists is operating normally as a member of the yet. storage cell. 121 Already Open The requested session is already open on Close the requested session before this NSC. It cannot be opened for multiple attempting this command again. session operation. 122 Session Not Open The requested session was not established Open the requested session before by opening the session. attempting this command again. 123 Not Marked Inoperative Case 1: The specified Continuous Access group cannot complete the operation until the disk group is marked permanently data lost. Case 2: The specified virtual disk is not in the thin provisioned overcommit state. Case 1: Resolve the RAID inoperative condition in the disk group. Case 2: Command is unnecessary on a non thin provisioned overcommit virtual disk. 124 Media Not Available 125 Battery System Failed 126 Member is Cache Data Lost 127 Internal Lock Collision Drive activity prevents the operation from being completed at this time. Retry the operation later. If the error persists, report the error to product support. The batteries do not allow the warm plug of Resolve degraded battery situation. a controller. The virtual disk is cache data lost. Resolve the cache data lost situation on the virtual disk. The resource needed to execute the request Retry the operation later. If the error is in use by internal DRM process. The persists, report the error to product operation can be retried later. support. 189