HP Elite 8300 HP Compaq Business PC Hardware Reference Guide - Elite 8300 Seri - Page 88
Installing Isolation Mounting Guide Screws in a 3.5-inch Drive,
View all HP Elite 8300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 88 highlights
6. Install guide screws on the sides of the drive. If you are installing a 2.5-inch drive, you must install the drive in an adapter bracket. NOTE: The hard drive uses 6-32 isolation mounting guide screws. Four extra guide screws are installed on the exterior of the hard drive bays. The HP-supplied isolation mounting guide screws are silver and blue. Refer to Installing and Removing Drives on page 71 for an illustration of the extra 6-32 isolation mounting guide screws location. If you are replacing a drive, transfer the guides screws from the old drive to the new one. ● If you are installing a 3.5-inch hard drive, install four isolation mounting guide screws (two on each side of the drive). Figure 3-26 Installing Isolation Mounting Guide Screws in a 3.5-inch Drive ● If you are installing a 2.5-inch hard drive: ◦ Slide the drive into the bay adapter bracket, ensuring the connector on the drive is fully inserted into the connector on the adapter bracket. Figure 3-27 Sliding the 2.5-inch Drive in the Adapter Bracket 80 Chapter 3 Microtower (MT) Hardware Upgrades