HP LH4r HP Netserver LC 3 User Guide - Page 37
Accessories
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
4 Accessories Installing Accessories If you are installing an ISA non-plug-and-play accessory board, follow the directions in the HP NetServer LC 3 Installation Road Map. If it is not available, refer to Information Assistant. Refer to "Configuring ISA Non-Plug-and-Play Board" in this chapter to reserve system resources for the board. If you are installing additional memory (DIMMs), PCI accessory boards, or SCSI mass storage devices follow the instructions in the HP NetServer LC 3 Installation Road Map. If it is not available, refer to Information Assistant. The backplane in the HP NetServer LC 3 has five PCI-only slots and one combined ISA/PCI slot for accessory boards. They are numbered 1-6 from left to right, as viewed from the rear of the HP NetServer. • Slot 1 is the combined ISA/PCI slot. • An optional disk array controller board (DAC) may be preinstalled in Slot 5. • Slot 6 contains a network interface controller board (NIC). The HP NetServer LC 3 chassis contains three hot-swap mass-storage slots and one open shelf for installation of an optional hard disk. • Shelf 1 contains a flexible disk drive. • Shelf 2 contains an IDE CD-ROM drive. • Shelf 3 can be used to install either a hard disk drive or another accessory. • The hot-swap subsystem occupies the lower area of the front panel. It can hold up to three hot-swap disk drive modules. 31