HP ProDesk 400 G1 Micro Maintenance and Service Guide ProDesk 400 G1 Microtowe - Page 132
Front I/O assembly, Blue connector labeled FRONT USB 3.0
View all HP ProDesk 400 G1 Micro manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 132 highlights
Front I/O assembly Description Front I/O assembly Spare part number 745037-001 1. Prepare the computer for disassembly (Preparation for disassembly on page 92). 2. Remove the access panel (Access panel on page 93). 3. Remove the front bezel (Front bezel on page 94). 4. Rotate the drive cage to its upright position. 5. Cut the plastic tie that secures the longer cable to the power supply. 6. Disconnect the cables from the system board as follows: ● Yellow connector labeled FRONT USB ● Blue connector labeled FRONT USB 3.0 ● Blue connector labeled FRONT AUD 122 Chapter 6 Removal and replacement procedures: Small Form Factor
Front I/O assembly
Description
Spare part number
Front I/O assembly
745037-001
1.
Prepare the computer for disassembly (
Preparation for disassembly
on page
92
).
2.
Remove the access panel (
Access panel
on page
93
).
3.
Remove the front bezel (
Front bezel
on page
94
).
4.
Rotate the drive cage to its upright position.
5.
Cut the plastic tie that secures the longer cable to the power supply.
6.
Disconnect the cables from the system board as follows:
●
Yellow connector labeled FRONT USB
●
Blue connector labeled FRONT USB 3.0
●
Blue connector labeled FRONT AUD
122
Chapter 6
Removal and replacement procedures: Small Form Factor