HP ProDesk 400 G1 Micro Maintenance and Service Guide ProDesk 400 G1 Microtowe - Page 79
Installing a 3.5-inch device (model 480 and model 490
View all HP ProDesk 400 G1 Micro manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 79 highlights
Installing a 3.5-inch device (model 480 and model 490) 1. Prepare the computer for disassembly (Preparation for disassembly on page 42). 2. Remove the access panel (Access panel on page 43). 3. Remove the front bezel (Front bezel on page 44). Remove the front bezel. If you are installing a drive in a bay covered by a bezel blank, remove the bezel blank. 4. Slide the device into the drive bay (1) and install the two 6-32 mounting screws in the side of the device (2) to secure it in place. NOTE: HP has supplied four 6-32 mounting screws on the front of the chassis behind the bezel. Refer to Drives on page 59 for an illustration of the extra mounting screws location. When replacing a device, use the two 6-32 mounting screws that were removed from the old device to install the new one. Drives 69