HP ProDesk 400 G1 Micro Maintenance and Service Guide ProDesk 400 G1 Microtowe - Page 73
Removing a 5.25-inch drive, Installing a 5.25-inch drive
View all HP ProDesk 400 G1 Micro manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 73 highlights
Removing a 5.25-inch drive CAUTION: All removable media should be taken out of a drive before removing the drive from the computer. 1. Prepare the computer for disassembly (Preparation for disassembly on page 42) 2. Remove the access panel (Access panel on page 43) 3. Remove the front bezel (Front bezel on page 44) 4. Disconnect the power cable and data cable from the back of the drive. CAUTION: When removing the cables, pull the tab or connector instead of the cable itself to avoid damaging the cable. 5. Remove the two black M3 mounting screws from the side of the drive (1) and slide the drive out of the front of the drive bay (2). Installing a 5.25-inch drive NOTE: HP does not offer a 5.25-inch optical drive for this computer model. A 5.25-inch optical drive can be purchased through a third-party vendor. 1. Prepare the computer for disassembly (Preparation for disassembly on page 42) 2. Remove the access panel (Access panel on page 43) 3. Remove the front bezel (Front bezel on page 44). If you are installing a drive in a bay covered by a bezel blank, remove the bezel blank. See Bezel blanks on page 45 for more information. Drives 63