HP ProDesk 400 G1 Micro Maintenance and Service Guide ProDesk 400 G1 Microtowe - Page 75
Removing a 3.5-inch device, Remove the access panel
View all HP ProDesk 400 G1 Micro manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 75 highlights
6. Connect the power cable (1) and data cable (2) to the back of the hard drive. NOTE: The power cable for the hard drives is a two-headed cable that is routed from the power supply to the rear of the hard drive bays. 7. Connect the opposite end of the data cable to one of the white (model 400) or light blue (model 490) SATA connectors on the system board. NOTE: Refer to System board connections - model 400 on page 56 or System board connections - model 480 on page 57 for an illustration of the system board drive connectors. Removing a 3.5-inch device CAUTION: All removable media should be taken out of a drive before removing the drive from the computer. 1. Prepare the computer for disassembly (Preparation for disassembly on page 42) 2. Remove the access panel (Access panel on page 43) 3. Remove the front bezel (Front bezel on page 44) Drives 65