HP StoreOnce D2D4324 HP StoreOnce Backup System CLI Reference Guide (BB877-909 - Page 42
hardware reboot, must be entered to verify
![]() |
View all HP StoreOnce D2D4324 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
hardware reboot NOTE: This command applies to multi-node products only. Description of Command Function Reboots the StoreOnce appliance nodes. If a file server node is defined in the command entry, only this node is rebooted. Command Syntax hardware reboot [NODEX] Command Authority Administrator Command Object Requirements NODEX - As an option, this can be used to define an individual file server node. X is a unique numeric index. NODEX is a label uniquely defining the hardware component. It was assigned during the initial automatic hardware initialization and configuration. A complete list of the NODEX labels can be obtained using the hardware show node status command (see "hardware show node status" (page 48)). If a file server node is defined, only this node is rebooted. If no nodes are defined, all the nodes in the appliance are rebooted. Command Parameter Requirements Not applicable - no parameters exist within this command. Requirements for Command Execution • The command entry must conform to the command syntax. • At least one system with an active CLI must exist. • If a file serving node is defined in the command entry, the defined node must be powered on. Successful Command Output Upon successfully sending the reboot request, the following is displayed: reboot request successfully sent NOTE: This message only indicates the success for the reboot request. The hardware show node status command (see "hardware show node status" (page 48)) must be entered to verify that the server nodes rebooted correctly. Also, if the reboot applies to the node currently supporting the CLI interface, the session will terminate following this command. Command Operation during Abnormal Conditions • If the command does not conform to the required syntax, the following is displayed: Command Failed - the command does not conform to the required syntax, SYNTAX, where SYNTAX is the command syntax as described under Command Syntax in this section. • If the defined node is not powered up, the following is displayed: Command Failed - NODEX is not rebooted, where NODEX is the file server node defined for reboot in the command entry. Example # hardware reboot reboot request successfully sent 42 Alphabetical List of Commands and Details
![](/manual_guide/products/hewlettpackard-d2d2502i-hp-storeonce-backup-cli-reference-guide-bb87790906-2013-b3556cc/42.png)