HP StoreOnce D2D4324 HP StoreOnce Backup System CLI Reference Guide (BB877-909 - Page 94
net show status, Show subnetwork status
![]() |
View all HP StoreOnce D2D4324 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 94 highlights
net show status NOTE: This command applies to single-node products only. Description of Command Function Displays information on the network status. Command Syntax net show status [subnet ][port ][all] Command Authority Operator and Administrator Command Object Requirements Not applicable - no parameters exist within this command. Command Parameter Requirements • subnet - This parameter shows subnetwork status. • port- This parameter shows port status. Use all to show status for all ports. • all- This parameter is optional. If included in the command sequence, shows the status of all subnets or ports, respectively. Requirements for Command Execution • The command entry must conform to the command syntax. • All object values must be valid; see the object descriptions for details. Successful Command Output Upon successful completion of the command, information on the external network configuration is displayed. Command Operation during Abnormal Conditions If the command does not conform to the required syntax, the following is displayed: Command Failed - the command does not conform to the required syntax, SYNTAX, where SYNTAX is the command syntax as described under Command Syntax in this section. Example Show general network status:# net show status Show subnetwork status: # net show status subnet subnet1 Show port status: # net show status port eth0 Show all port status: # net show status port all Show top level status of all subnets: net show status all 94 Alphabetical List of Commands and Details
![](/manual_guide/products/hewlettpackard-d2d2502i-hp-storeonce-backup-cli-reference-guide-bb87790906-2013-b3556cc/94.png)