HP Tc2100 hp server tc2100 installation sheet (English) - Page 10
Applying Power to the Server, 6e Replacing the covers, Check/Set the Power, Supply Input Voltage
View all HP Tc2100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Chapter 1 6e) Replacing the covers Setting Up the HP Server • Ensure all cables are properly routed and all components are fully seated, before replacing the covers. • For details refer to Chapter 3, "Opening and Closing the HP Server." Applying Power to the Server 7) Check/Set the Power Supply Input Voltage Power Connector • Check the input voltage switch on the power supply located on the rear of the Server below the power connector, as shown below. • The input voltage switch has two positions: 115 or 230 volts - 230 volts is default position. (Switch shown in 115 volts position.) 4 Input Voltage Switch
Chapter 1
Setting Up the HP Server
4
6e) Replacing the covers
•
Ensure all cables are properly routed
and all components are fully seated,
before replacing the covers.
•
For details refer to Chapter 3,
"Opening and Closing the HP
Server."
Applying Power to the Server
7) Check/Set the Power
Supply Input Voltage
•
Check the input voltage switch on the power
supply located on the rear of the Server below
the power connector, as shown below.
•
The input voltage switch has two positions: 115
or 230 volts – 230 volts is default position.
(Switch shown in
115 volts position.)
Input Voltage
Switch
Power
Connector