HP Vectra XM 5/xxx HP Vectra XM 5/xxx Series 3 - User Guide - Page 91

4 Troubleshooting Your PC and Using the SETUP Program Using the HP SETUP Program SETUP Item: What you can do: SCSI Accessory Boards View the SCSI BIOS ROM address for an HP SCSI Accessory Board Disable/Enable shadowing of the SCSI BIOS Flexible Disk Drives Security Features Parallel Port Serial Port Remote Program Load PCI Integrated Ethernet Interface Configure the flexible disk drives Choose which flexible disk drive to boot the system from Define if the flexible disk controller is integrated on the system board or on an accessory board • Set the System Administrator Password • Configure your PC to Start With Keyboard Locked • Enable/Disable Start from Flexible Disk • Enable/Disable Start from Hard Disk • Enable/Disable the Flexible Disk Drives • Enable/Disable the Hard Disk Drives • Allow/Disallow writing to Flexible Disks • Select the level of support for Plug and Play Accessories Disable/Enable the Parallel Port View I/O address and IRQ channel used by Parallel Port Select Parallel Port mode Centronics, ECP, EPP 1.7, or EPP 1.9 Disable/Enable the Serial Ports View I/O address and IRQ channel used by the Serial Ports Remote Start can be configured as None or Ethernet Select which Protocol will be used Enable/Disable the PCI integrated Ethernet interface View the MAC address Video VGA Enhanced/Ergonomic Modes Select which Video Adapter Mode is used Enable/Disable the copying of the Video BIOS to RAM for ISA Video Controllers (the PCI Video BIOS is always shadowed) Select Video Refresh Rates IRQ Map for Accessory View available IRQ channels and select which IRQs are used by Boards installed accessory boards English 79