HP Xw4200 Getting Started Guide HP Workstations xw4100, xw4200, xw6200, and xw - Page 45
Interpreting xw4100 Diagnostic Lights and Audible, Codes, Power-On Self-Test POST. - beep codes
UPC - 829160426853
View all HP Xw4200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
Troubleshooting Problem Power LED blinks Red six times, once every second, followed by a two second pause, and the workstation beeps six times. Probable Cause Video card is not seated properly or is bad, or system board is bad. Recommended Solution For systems with a graphics card: 1. Reseat the graphics card. Power on the system. 2. Replace the graphics card. 3. Replace the system board. Interpreting xw4100 Diagnostic Lights and Audible Codes This section covers the front panel light (LED) error and operation codes as well as the audible codes that may occur before or during the Power-On Self-Test (POST). NOTE: If you see blinking LEDs on a PS/2 keyboard, look for blinking LEDs on the front panel of the workstation and refer to the following table to determine the front panel LED codes. Recommended actions in the following table are listed in the order in which they should be performed. Getting Started Guide www.hp.com 4-11