HP rp7405 User Guide, Third Edition - hp rp7405/rp7410 Servers - Page 37
Right-Front View of hp rp7405/rp7410, Front panel, display board
View all HP rp7405 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
Introduction Detailed hp rp7405/rp7410 Description Figure 1-10 Right-Front View of hp rp7405/rp7410 PCI cards Front panel display board PCI DC-to-DC converters Cell boards Bulk powers supplies Slide The PCI I/O card section, located towards the rear, is accessed by removing the top cover. The PCI OLR fan modules are located in front of the PCI cards. These six 9.2 cm fans are housed in plastic carriers. They are configured in two rows of three fans. The MP/SCSI MP Core I/O boards are positioned vertically at the rear of the chassis. The PCI card bulkhead connectors are located in the top rear portion of the product volume. Four OLR system fan modules, externally attached to the chassis, are 15 cm (6.5-inch) fans. Two fans are mounted on the front surface of the chassis and two are mounted on the rear surface. Redundant line cords attach to the floating AC connector module at the bottom rear. Two 20-amp cords are required to power the server. Two additional line cords provide redundancy. A cable harness that connects from the rear of the BPSs to the system backplane provides DC power distribution. Access the system backplane is accomplished by removing the left side cover. The system backplane inserts by a guide/insertion mechanism using a single large jack screw assembly. SCSI ribbon-cable assemblies route from the mass storage area to the backside of the system backplane and to the Procurium PCI MP Core I/O card. Chapter 1 15