HP rp7405 User Guide, Third Edition - hp rp7405/rp7410 Servers - Page 52
Attaching CMA to the Server, Installing Add-On Products, Cell Boards, MP Core I/O Cards
View all HP rp7405 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
Installation Unpacking the Server Step 2. Attach the other end of the CMA to the server using the thumb screws that came with the CMA. Figure 2-16 Attaching CMA to the Server Installing Add-On Products This section explains load orders and dependencies for add-on products. For physical installation procedures, refer to that components replacement procedure in Chapter 4, "Removal and Replacement." If installing add-on products to an existing server, follow operating system backup and shutdown procedures before powering off the server. Cell Boards The server requires at least one cell board to operate. Install the first cell board slot 1 (lower slot) and the second cell board in slot 0 (upper). Cell Board 0 enables the PCI cards in Chassis 0 and Cell Board 1 enables the PCI cards in Chassis 1. MP Core I/O Cards MP Core I/O consists of two cards that must be installed in pairs: the MP/SCSI and the LAN/SCSI. The first (primary) set of MP Core I/O cards is installed as follows: MP/SCSI in MP/SCSI slot 1 (lower slot) and LAN/SCSI in PCI slot 8 of Chassis 1 (from the rear, the extreme right-hand PCI slot). The second set of MP Core I/O cards is installed as follows: MP/SCSI in MP/SCSI slot 0 and LAN/SCSI in PCI slot 1 of Chassis 0. Cell Board 0 is required to enable the MP/SCSI slot 0 (upper slot) and LAN/SCSI slot 1 in Chassis 0 (from the rear, the extreme left-hand PCI slot). 30 Chapter 2