HP xp8000 HP L1581A advanced connectivity module - (English) User Guide - Page 48

To manage the projector using the on-screen menu, are displayed in the on-screen menu.

Page 48 highlights

Maintaining the System To manage the projector using the on-screen menu The projector's on-screen menu is described in detail in the projector manual. However, when you install a connectivity module, certain new menu entries are displayed in the on-screen menu. New menu entries with module installed Quick choice Wireless Presenter Displays information needed by Wireless Presenter-to-Go so it can connect to the projector. Input (This menu was named "Connect" in early firmware versions.) Connectivity module Shows the input signal from the current wired or wireless presenter. Setup Enable sources Sets whether input sources connected to the Connectivity module connectivity module are searched or ignored when the projector searches for an input. Help About the network Displays the current configuration of the wired and wireless network ports on the connectivity module. The wireless configuration and certain wired settings must be changed using the Web interface. See "To manage the projector from the Web" on page 49. 48 User's Guide

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72

48
User’s Guide
Maintaining the System
To manage the projector using the on-screen menu
The projector’s on-screen menu is described in detail in the projector manual.
However, when you install a connectivity module, certain new menu entries
are displayed in the on-screen menu.
New menu entries with module installed
Quick choice
Wireless Presenter
Displays information needed by Wireless
Presenter-to-Go so it can connect to the projector.
Input
(This menu was named “Connect” in early firmware
versions.)
Connectivity module
Shows the input signal from the current wired or
wireless presenter.
Setup
Enable sources
Connectivity module
Sets whether input sources connected to the
connectivity module are searched or ignored when
the projector searches for an input.
Help
About the network
Displays the current configuration of the wired and
wireless network ports on the connectivity module.
The wireless configuration and certain wired
settings must be changed using the Web interface.
See “To manage the projector from the Web” on
page 49.