IBM 8658 User Guide - Page 148
Error, Code/Symptom, FRU/Action, Processor, System, Board, Cable, Fixed, Cables
![]() |
UPC - 087944602644
View all IBM 8658 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 148 highlights
Error Code/Symptom FRU/Action 0001200 (Machine check architecture error) 1. Processor 2. Optional Processor 3. System Board 0001295 (ECC circuit check) 1. System Board 1301 (I2C cable to front panel not found) 1. Cable 2. Front Panel 3. Power Switch Assembly 4. System Board 1302 (I2C cable from system board to power on and reset switches not found) 1. Cable 2. Power Switch Assembly 3. System Board 1303 (I2C cable from system board to power backplane not found) 1. Cable 2. Power Backplane 3. System Board 1304 (I2C cable to diagnostic LED board not found) 1. Cable 2. Diagnostic LED Board 3. Power Switch Assembly 4. System Board 1600 (The Service Processor is not functioning) Do the following before replacing a FRU: 1. System Board 1. Ensure that a jumper is not installed on J51. 2. Remove the ac power to the system, wait 20 seconds; then, re-connect the ac power. Wait 30 seconds; then, power-on the system. 1601 (The system is able to communicate to the Service 1. System Board Processor, but the Service Processor failed to respond at the start of POST.) Do the following before replacing a FRU: 1. Remove the ac power to the system, wait 20 seconds; then, re-connect the ac power. Wait 30 seconds; then, power-on the system. 2. Flash update the Service Processor. 1762 (Fixed Disk Configuration error) 1. Fixed Disk Cables 2. Run Configuration/Setup 2 3. Fixed Disk Adapter 4. Fixed Disk Drive 5. SCSI Backplane 6. System Board 138 : Netfinity 5100 Type 8658 Models 11Y, 21Y, 31Y, 41Y, 51Y, 1RY, 2RY, 3RY, 4RY, 5RY
![](/manual_guide/products/ibm-8658-user-guide-f978985/148.png)