IBM 8658 User Guide - Page 80
Installing, cover, tower
![]() |
UPC - 087944602644
View all IBM 8658 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 80 highlights
3 Fan assembly latch 4 Fan assembly To replace the fan assembly: 1. Turn off the server and peripherals. 2. Remove the cover. See "Removing the cover, door, and bezel" on page 48 for details. 3. Determine which fan assembly to replace by checking the LED on each fan; a lit LED indicates the fan to replace. 4. Remove the fan assembly from the server by pressing the blue release latch for the fan and pulling the fan away from the server. 5. Slide the replacement fan assembly into the server until it clicks into place. 6. Verify that the FAN LED on the diagnostic panel is not lit. If the FAN LED is lit, reseat the fan. 7. Replace the cover. 8. Turn on the server and peripherals. Installing the cover If you have a tower model, continue with "Installing the cover (tower)." If you have a rack model, go to "Installing the cover (rack)" on page 71. Installing the cover (tower) 1 Slots 2 Left-side cover To install the server left-side cover: 1. Align the cover with the left side of the server, about 25 mm (1 inch) from the front of the server; place the bottom of the cover on the bottom rail of the chassis. 2. Insert the tabs at the top of the cover into the slots at the top of the server. 3. Hold the cover against the server and slide the cover toward the front of the server until the cover clicks into place. 70 : Netfinity 5100 Type 8658 Models 11Y, 21Y, 31Y, 41Y, 51Y, 1RY, 2RY, 3RY, 4RY, 5RY
![](/manual_guide/products/ibm-8658-user-guide-f978985/80.png)