IBM IC35L020 Hard Drive Specifications - Page 189
Standby E2h/96h
View all IBM IC35L020 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 189 highlights
15.33 Standby (E2h/96h) Command Block Output Registers Register 7 6 5 4 3 2 1 0 Data Feature Sector Count V V V V V V V V Sector Number Cylinder Low Cylinder High Device/Head 1 - 1 D - - - - Command 1 1 1 0 0 0 1 0 Command Block Input Registers Register 7 6 5 4 3 2 1 0 Data Error see below Sector Count Sector Number Cylinder Low Cylinder High Device/Head Status see below Error Register 76543210 CRC UNC 0 IDN 0 ABT T0N AMN 00000V00 Status Register 7 6 5 4 3 2 10 BSY RDY DF DSC DRQ COR IDX ERR 0 V 0 V - 0 -V Figure 133. Standby Command (E2h/96h) The Standby command causes the device to enter the Standby Mode immediately and to set the auto power down time-out parameter (standby timer). When the Standby mode is entered, the drive is spun down but the interface remains active. If the drive is already spun down, the spin down sequence is not executed. During the Standby mode the drive will respond to commands but there is a delay while waiting for the spindle to reach operating speed. The automatic power down sequence is enabled and the timer starts counting down when the drive returns to Idle mode. Deskstar 60 GXP Hard disk drive specification 175