IBM IC35L020 Hard Drive Specifications - Page 29
Operating modes, 3.8 Mode transition times, Low RPM Idle
View all IBM IC35L020 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
4.3.7 Operating modes Operating mode Spin-up Seek Write Read Low RPM Idle Unload Idle Idle Standby Sleep Description Start up time period from spindle stop or power down Seek operation mode Write operation mode Read operation mode Spindle rotation @4,500 RPM with heads unloaded Spindle rotation @7,200 RPM with heads unloaded The spindle motor and servo system are working normally. Commands can be received and processed immediately. The actuator is unloaded and spindle motor is stopped. Commands can be received immediately. The actuator is unloaded and spindle motor is stopped. Only a soft reset or hard reset can change the mode to standby. Figure 14. Operating modes Note: Upon power down or spindle stop a head locking mechanism will secure the heads in the OD parking position. 4.3.8 Mode transition times Mode transition times are shown below. From Standby To RPM Transition time (typical) (seconds) Idle 0-7200 (3 disks) 11 seconds (typical) 31 (max.) Idle Standby Sleep Unload Idle Low RPM Idle Standby Sleep Standby Idle Idle 7200-0 0 0 7,200 4500-7200 Immediately Immediately Immediately 1.1 (typical) 4.8 seconds (3 Disks, typical) Note: The actual spin down time will exist, however the command will be processed immediately. Figure 15. Mode transition times Deskstar 60 GXP Hard disk drive specification 15