Icom IC-2300H Instruction Manual - Page 13

2 SETTING A FREQUENCY ■■Preparation D Turning power ON/OFF ➥ Hold down [ ] for 1 second to turn the power ON or OFF. D VFO mode selection The IC-2300H has 2 basic operating modes; VFO mode and memory mode. ➥ Push [V/MH­z­ ] to select the VFO mode. • Push [M/CALL] to select the memory mode. Using the HM-133V ➥ Push [VFO] to select the VFO mode. Hold down [ ] for 1 second. Push [V/MHz] to select the VFO mode. MUTE NAR MID LOW LOCK SET ANM MONI DIGITAL PRIO AO BUSY DUP LOW T-SCAN TONE PRIO M/CALL SCAN V/ MHz VFO mode Push [M/CALL] to select the memory mode. MUTE NAR MID LOW LOCK SET DIGITAL PRIO AO BUSY ANM MONI DUP LOW T-SCAN TONE PRIO M/CALL Memory mode SCAN V/ MHz ■■Using the dial ➥ Rotate [DIAL] to set the frequency. • If necessary, push [V/MH­z­ ] to select the VFO mode. • T he frequency changes according to the selected tuning step. (p. 6) • Push [V/MH­z­ ] one or more times, to toggle the frequency step between 1 MHz and 10 MHz, if desired. If the scan starts: • Holding down [SCAN] (V/MHz) for 1 second will start a scan. Push [V/MHz­­ ] again to cancel it. Rotate [DIAL] to set the frequency. MUTE NAR MID LOW LOCK SET DIGITAL PRIO AO BUSY ANM MONI DUP LOW T-SCAN TONE PRIO M/CALL SCAN V/ MHz In the VFO mode [DIAL] Push [V/MHz] to toggle the tuning step. DIGITAL PRIO AO BUSY MUTE NAR MID The 1 MHz tuning step is selected. LOW LOCK ANM DUP T-SCAN PRIO SCAN SET MONI LOW TONE M/CALL V/MHz ■■Using the keypad on the HM-133V z If necessary, push [VFO] to select the VFO mode. x Push [ent] to activate the keypad for numerical input. c Push 6 keys to input the frequency. • W hen a digit is mistakenly input, push [ent] to clear the input, and then re-enter from the 1st digit. • Push [clr] to clear the input digits and recall the previous frequency. [EXAMPLE]: Setting the frequency to 145.3625 MHz. Push Push Push MUTE NAR MID LOW LOCK SET ANM MONI DIGITAL PRIO AO BUSY DUP LOW T-SCAN TONE PRIO M/CALL SCAN V/ MHz MUTE NAR MID LOW LOCK SET ANM MONI DIGITAL PRIO AO BUSY DUP LOW T-SCAN TONE PRIO M/CALL SCAN V/ MHz MUTE NAR MID LOW LOCK SET ANM MONI DIGITAL PRIO AO BUSY DUP LOW T-SCAN TONE PRIO M/CALL SCAN V/ MHz ■■Using [Y] or [Z] on the HM-133V Push MUTE NAR MID LOW LOCK SET ANM MONI DIGITAL PRIO AO BUSY DUP LOW T-SCAN TONE PRIO M/CALL SCAN V/ MHz ➥ Push [Y] or [Z] to select the desired frequency. • Holding down [Y] or [Z] for 1 second activates a scan. If a scan has started, push [Y] or [Z] again or push [clr] to cancel it. 5