Icom IC-2300H Instruction Manual - Page 14
■ Tuning step selection
View all Icom IC-2300H manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
SETTING A FREQUENCY 2 ■ Tuning step selection The tuning step is the smallest selectable frequency increment you can set the operating frequency. The following tuning steps are selectable. • 5 kHz • 6.25 kHz • 10 kHz • 12.5 kHz • 15 kHz • 20 kHz • 25 kHz • 30 kHz • 50 kHz NOTE: For convenience, select the tuning step that matches the frequency intervals of the repeaters in your area. q If necessary, push [V/MHz ] to select the VFO mode. w Push [SET] to enter the Set mode. e Push [SET] or [MONI] one or more times, until "TS" appears, as shown to the right. r Rotate [DIAL] to select the desired tuning step. t Push any key, other than [SET] or [MONI], to save the entry and exit the Set mode. Using the HM-133V z If necessary, push [VFO] to select the VFO mode. x Push [set] to enter the Set mode. c Push [set] or [ent] one or more times until "TS" appears. v Push [Y] or [Z] to select the desired tuning step. b Push [CLR] to save the entry and exit the Set mode. 15 kHz tuning step MUTE NAR MID LOW LOCK SET ANM MONI DIGITAL PRIO AO BUSY DUP LOW T-SCAN TONE PRIO M/CALL SCAN V/ MHz Push one of these keys, to exit the Set mode. 00 1 2 3 4 [DIAL] 5 6 7 8 9 10 11 12 13 6