Icom IC-2300H Instruction Manual - Page 59

■ Microphone keys [F-1] and [F-2] on the supplied HM-133V memorize the transceiver settings. The [UP] and [DOWN] keys on the standard or optional mi- crophone (other than the HM-133V) can be assigned func- tions like the function keys on the transceiver's front panel. DD[F-1] and [F-2] keys on HM-133V The following functions can be assigned to the microphone's [F-1] and [F-2] keys. • Operating frequency • Repeater settings (offset direction and offset, tone ON/OFF and frequency) • Tone/DTCS squelch (ON/OFF, frequency/code and polarity) • Transmit output power setting • Setting the Set mode items • Setting the Initial Set mode items (except "Display Type") ➥ Programming the function Select the desired function, and then hold down [F-1] or [F-2] for 1 second. • 3 beeps sound. To program the Set and Initial Set modes items, push [FUNC] , and then hold down [F-1] or [F-2] for 1 second. ➥ Recalling the function Push [F-1] or [F-2] . To recall the Set and Initial Set modes items, push [FUNC] , and then [F-1] or [F-2] . OTHER FUNCTIONS 11 00 1 2 3 4 5 6 7 8 9 10 11 12 13 DD[UP] and [DN] keys on a microphones other than the HM-133V When turning ON the transceiver's power, the following functions are pre-assigned to [UP] or [DN] on microphones other than HM-133V. [UP] : Channel up; hold down for 1 second to start the scan, push again to stop it. [DN] : Channel down; hold down for 1 second to start the scan, push again to stop it. ➥ Assigning a function q Turn OFF the power. w W hile holding down the desired key on the trans- ceiver and either [UP] or [DN] keys on the microphone, turn ON the power. • The function is assigned to the key. ➥ Clearing an assignment q Turn OFF the power. w W hile holding down the desired [UP] or [DN] key on the microphone, turn ON the power. 51